Product Features:

◆It can be connected to an external speed display board to display the speed; it can also be connected to a computer to set drive parameters

◆Double closed loop design of current and speed, large torque at low speed, stable operation;

◆High torque and high speed output, the highest speed can reach 10000rpm/min;

◆Speed regulation mode: 0-5V analog quantity and 10 Hz -300Hz PWM speed regulation, which is convenient for users to use;

◆There are EN (enable), DIR (direction) and other signal input terminals;

◆Can output speed measurement pulse, (photoelectric isolation, gate output);

◆It has protection functions such as overcurrent, overvoltage, undervoltage, overheating, and motor blocking

Electrical performance:

Power supply: DC18~50V DC power supply

Output current: peak 10A

Rated power: 480W max

Insulation resistance: >500MΩ at room temperature

Insulation strength: 0.5kv under normal temperature and pressure, 1 minute.

Use environmental parameters:

Cooling method: natural air cooling (forced air cooling is recommended)

Occasion: Try to avoid powder layer, oil mist, and corrosive gas

Temperature: 0℃~+50℃

Humidity: <80%RH

Vibration: Max 4.9m/s²

Storage temperature: -20℃~+65℃

Dimensions: 118*75.5*34mm

Weight: about 0.3kg

Driver wiring port description

Function

Identification

Description

Indicator light

POWER

green power indicator light, power on, indicating that the power supply is normal

ALARM

red status indicator, slow flashing, waiting. fast flashing, running, and it changes with the motor speed, indicator always on for failure or offline

RS232  Communication port

TTL

can be connected to an external speed display board to display the speed; it can also be connected to a computer to set drive parameters

Control signal terminal

5V1

Control signal power supply positive

VSP

1. External speed control signal, adjust the motor speed through an external potentiometer
2. PWM speed regulation: connect the positive terminal of PWM to VSP, and the negative terminal to GND1, input frequency 10Hz-300kHz, and change the duty cycle for speed regulation

FG

Motor speed pulse output, can be converted into the actual speed of the motor by measuring the frequency of this signal

DIR

High and low level control the motor forward and reverse, connect to GND1, the motor will reverse, when not connected to GND1 or connect to +5V1, the motor will rotate forward, when switching between forward and reverse, in order to reduce the impact, first set EN to stop the motor

EN

Motor EN control, EN connects to GND1, the motor rotates, if EN is not connected to GND1, the motor does not rotate

GND1

Control signal power ground

Hall signal terminal

5V2

Motor Hall power supply positive

HU

Hall sensor signal U phase input

HV

Hall sensor signal V phase input

HW

Hall sensor signal W phase input

GND2

Motor Hall power ground

Motor and power terminal

U、V、W

Motor three-phase output signal, connected to motor winding

GND、V+

DC 24V~48V power supply input