Product Features:
◆Current loop design, large torque at low speed, stable operation;
◆High torque and high speed output, the maximum speed is up to 10000rpm/min (depending on the motor speed);
◆With pulse speed output, you can observe the motor speed at any time;
◆Speed regulation mode: 0-5V analog quantity and 10 Hz -300Hz PWM speed regulation, which is convenient for users to use;
◆Start-stop EN control signal, direction signal input;
Electrical performance:
Power supply: DC18~50V DC power supply
Output current: peak 5A
Rated power: 240W max
Insulation resistance: >500MΩ at room temperature
Insulation strength: 0.5kv under normal temperature and pressure， 1 minute.
Use environmental parameters:
Cooling method: natural air cooling (forced air cooling is recommended)
Occasion: Try to avoid powder layer, oil mist, and corrosive gas
Temperature: 0℃~+50℃
Humidity: <80%RH
Vibration: Max 4.9m/s²
Storage temperature: -20℃~+65℃
Dimensions: 96*61.5*27.5mm
Weight: about 0.15kg
Driver wiring port description | ||
Function | Identification | Description |
Indicator light | POWER | green power indicator light, power on, indicating that the power supply is normal |
ALARM | red status indicator, slow flashing, waiting. fast flashing, running, and it changes with the motor speed, indicator always on for failure or offline | |
Control signal terminal | 5V1 | Control signal power supply positive |
VSP | External speed control signal, adjust the motor speed through an external potentiometer | |
FG | Motor speed pulse output, can be converted into the actual speed of the motor by measuring the frequency of this signal | |
DIR | High and low level control the motor forward and reverse, connect to GND1, the motor will reverse, when not connected to GND1 or connect to +5V1, the motor will rotate forward, when switching between forward and reverse, in order to reduce the impact, first set EN to stop the motor | |
EN | Motor EN control, EN connects to GND1, the motor rotates, if EN is not connected to GND1, the motor does not rotate | |
GND1 | Control signal power ground | |
Hall signal terminal | 5V2 | Motor Hall power supply positive |
HU | Hall sensor signal U phase input | |
HV | Hall sensor signal V phase input | |
HW | Hall sensor signal W phase input | |
GND2 | Motor Hall power ground | |
Motor and power terminal | U、V、W | Motor three-phase output signal, connected to motor winding |
GND、V+ | DC 24V~48V power supply input | |